Service Guide

Server Utilities
144 Intel
®
Server System R1000RP Service Guide
Option Values: <None>
Help Text:
Exit BIOS Setup Utility after saving changes. The system will reboot if required.
The [F10] key can also be used.
Comments: Selection only. Select this line and press the <Enter> key to exit Setup
with any changes in BIOS settings saved. If there have been no changes made in the settings,
the BIOS will resume executing POST.
If changes have been made in BIOS settings, a confirmation pop-up will appear. If the “Save
Changes & Exit” action is positively confirmed, any persistent changes will applied and saved
to the BIOS settings in NVRAM storage, then the system will reboot if necessary (which is
normally the case). If the “Save Changes & Exit” action is not confirmed, BIOS will resume
executing Setup.
The <F10 > function key may also be used from anyplace in Setup to initiate a “Save Changes
& Exit” action.
Back to [Save & Exit Screen] — [Screen Map]
2. Discard Changes and Exit
Option Values: <None>
Help Text:
Exit BIOS Setup Utility without saving changes.
The [Esc] key can also be used.
Comments: Selection only. Select this line and press the <Enter> key to exit Setup
without saving any changes in BIOS settings. If there have been no changes made in the
settings, the BIOS will resume executing POST.
If changes have been made in BIOS settings, a confirmation pop-up will appear. If the “Discard
Changes & Exit” action is positively confirmed, all pending changes will be discarded and
BIOS will resume executing POST. If the “Discard Changes & Exit” action is not confirmed,
BIOS will resume executing Setup without discarding any changes.
The <Esc > key may also be used in Setup to initiate a “Discard Changes & Exit” action.
Back to [Save & Exit Screen] — [Screen Map]
3. Save Changes
Option Values: <None>
Help Text: Save Changes made so far to any of the setup options.
Comments: Selection only. Select this line and press the <Enter> key to save any
pending changes in BIOS settings. If there have been no changes made in the settings, the BIOS
will resume executing POST.
Also, the user should be aware that most changes require a reboot to become active. If changes
have been made and saved, without exiting Setup, the system should be rebooted later even if
no additional changes are made.
Back to [Save & Exit Screen] — [Screen Map]
4. Discard Changes
Option Values: <None>
Help Text: Discard Changes made so far to any of the setup options.