User Guide

8 Intel
®
System Configuration Utility – User Guide
-Delete the contents of the directory where the utility is installed.
C. Windows/WinPE
a. Copy the syscfg utility zip file into your local directory (e.g. C:\syscfg)
b. Unzip the zip file
c. The following folders contain windows binaries and drivers under c:\syscfg
folder.
 Win_x64
 Win_x86
 Drivers
d. For 32 bit or EM64T Operating system, go to folder
"SyscfgVxx_0_BuildXX\Drivers\win\x86" or
"SyscfgVxx_0_BuildXX\Drivers\win\x64" and run install.cmd to install Intel
®
Intelligent Management Bus Driver Vxx.x, Intel
®
28F320C3 Flash Update Device
Driver Vxx.x and Intel
®
Intelligent Management Utility Device Vxx.x.
e. From the command prompt go to Win_x64 or Win_x86 folder and run the
desired commands for the utility
f. To uninstall SYSCFG run the following commands manually
 Delete the contents of the directory where the utility is installed.
 Manually uninstall drivers from the Device manager
3.2 Saving a Configuration
The utility supports saving BIOS and FW settings both in binary and in text mode (from a
text file, known as INI file). The advantage of using INI file is that you can modify and
change the values of any of the settings available in the INI file.
To save the BIOS and firmware configuration to a file, do the following:
1. Boot to one of the supported Operating Systems on the target system.
2. Change directories to the location of the syscfg executable. (This location must be
writable to allow you to save the system configuration.)
3. In Windows*, Windows Pre-installation Environment*, or EFI type: syscfg /s
filename
In Linux*, type: ./syscfg /s filename
When saving the settings to a file, you have the option to supply the file type (scf or ini).
The binary file filename.scf or filename.ini will contain the saved configuration. You can use
this file to restore the configuration on this target server or other servers using the /r
command.
In the absence of a user defined file type the default type would be ‘SCF. So if you neither
provide file type nor filename, the default filename will be syscfg.SCF