Technical Product Specification

Intel® Server System R1304BTSSFAN/ R1304BTLSFAN/ R1304BTLSHBN TPS

Appendix A: Integration and Usage Tips

 When adding or removing components or peripherals from the server board, AC power

must be removed. With AC power plugged into the server board, 5-Volt standby is still

present, even though the server board is powered off.

 When updating the BIOS and BMC, AC power must be on.

 Supports only the Intel

Xeon

Processor E3-1200 Series with 95W and less Thermal

Design Power (TDP). Does not support previous generations of the Intel

Xeon

processor.

 On the back edge of the server board are diagnostic LEDs that display a sequence of

amber POST codes during the boot process. If the server board hangs during POST, the

LEDs display the last POST event run before the hang.

 Supports only unbuffered DDR3 ECC DIMMs (UDIMMs). Does not support the mixing of

RDIMMs and UDIMMs.

 The Intel

Remote Management Module 4 (Intel

RMM4) lite connector is not compatible

with the Intel

Remote Management Module (Product Order Code – AXXRMM), the

Intel

Remote Management Module 2 (Product Order Code – AXXRMM2), or the Intel

Remote Management Module 3 (Product Order Code – AXXRMM3).

 Clear the CMOS with the AC power cord plugged in. Removing the AC power before

performing the CMOS clear operation causes the system to automatically power up and

immediately power down after the CMOS clear procedure is followed and AC power is

re-applied. If this happens, remove the AC power cord, wait 30 seconds, and then

re-connect the AC power cord. Power up the system and proceed to the <F2> BIOS

Setup utility to reset the needed settings.

 Normal Integrated BMC functionality is disabled with the force Integrated BMC update

jumper set to the “enabled” position (pins 2-3). The server should never be run with the

Integrated BMC force update jumper set in this position and should be used only when

the standard firmware update process fails. This jumper should remain in the default

(disabled) position (pins 1-2) when the server is running normally.

 When performing a normal BIOS update procedure, the BIOS recovery jumper must be

set to its default position (pins 1-2).

Revision 2.4