Service Guide

Intel

Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide 59

Replacing the Server Board

Removing the Server Board

1. Observe the safety and ESD precautions at the beginning of this book. See “Safety

Information” on page iii.

2. Power down the server and unplug all peripheral devices and the AC power cable.

3. Remove the server system cover. For instructions, see “Removing the Server

System Cover” on page 28.

4. Remove the processor air duct. For instructions, see “Removing the Processor Air

Duct” on page 30.

5. Remove the PCIe* Riser assembly. For instructions, see “Removing the PCIe*

Riser Assembly” on page 52.

6. Detach all cables connected to the server board.

7. Remove the heat sink and the processor. For instructions, see “Removing the Heat

Sink and Processor” on page 35.

8. Remove the DIMMs. For instructions, see “Removing DIMMs” on page 33.

9. Remove the nine screws from the server board and lift the server board from the

server system.

Figure 35. Removing the Server Board

AF003739