Service Guide

28 Intel

Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide

Removing and Installing the Server Cover

Removing the Server System Cover

You must operate the server system with the server system cover in place to ensure proper

cooling. You must remove the cover to add or replace components inside of the server.

None of the internal components are hot-swappable. Before removing the server system

cover, power down the server and unplug all peripheral devices and the AC power cable.

Note: You may need a non-skid surface or a stop behind the server system to prevent the server

system from sliding on your work surface.

1. Observe the safety and ESD precautions at the beginning of this book. See “Safety

Information” on page iii.

2. Turn off all peripheral devices connected to the server. Turn off the server.

3. Disconnect the AC power cord.

4. Remove the three screws at the front of the chassis and the screw at the end of the

chassis, see letter “A” in Figure 12

5. Push down the two buttons, then push rearward, see letter “B” in Figure 12. Slide

the cover back until it stops and then lift the cover upward to remove it, see letter

“C” in Figure 12.

Figure 12. Removing the Server System Cover

AF003681