Service Guide

Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide 51
Removing a Slimline Optical Drive
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28.
4. Press down the latch and then Slide the optical drive out through the front of
the system.
5. Disconnect the optical drive power and data cables.
6. Remove the screws that secure the latch to the optical drive. Save these screws for
future use.
7. If you are installing a replacement optical drive, skip the rest of these steps and
instead continue with “Installing a Slimline Optical Drive” on page 49, Step 5 on
page 49.
8. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29.