User Guide

50 Intel® Integrated RAID Solution User Guide
Sample Output
Following is an example of the output of the BOOTIR command, showing a RAID volume
as the primary boot device, after it was selected with the
BOOTIR command. The format
and fields in the output vary depending on the types of installed controllers.
----------------------------------------------------------------
IR Volume information
----------------------------------------------------------------
IR volume 1
Volume ID : 174
Status of volume : Degraded (DGD)
RAID level : RAID1
Size (in MB) : 69376
Boot : Primary
Physical hard disks :
PHY[0] Enclosure#/Slot# : 2:8
PHY[1] Enclosure#/Slot# : 2:11
----------------------------------------------------------------
BOOTENCL
The BOOTENCL command selects a specific enclosure/slot as the primary boot device. If
an enclosure/slot is selected as the boot location, the
DISPLAY command displays this
information in the Enclosure information section.
Command Line
sas3ircu <controller_#> bootencl <Enclosure:Bay>
Parameters
• <controller_#> – The index of the controller with the enclosure/slot that you
want to select as the primary boot device.
• <Enclosure:Bay> – The enclosure:bay value of the disk drive that you want to
select as the primary boot device.
Program Return Value
0x00 – SUCCESS: Command completed successfully.
0x01 – FAILURE: Bad command-line arguments or operational failure.
0x02 – ADAPTER_NOT_FOUND: Cannot find specified adapter.