Technical Product Specification
Hardware IntelP®P RAID Controller RS2PI008 Technical Product Specification
2.4 Hardware Architectural Features
Table 5 Hardware Architectural Features
Feature Intel® RAID Controller RS2PI008
RAID levels 0, 1, 5, 6, 10, 50, 60
Number of devices Up to 240 devices per controller
Device types SAS and SATA hard drives
Data transfer rate 600 MB/s per port
PCI bus x8 PCI Express* 2.0
Memory 512 MB ECC DDR2 800-MHz SDRAM integrated on the controller
Battery backup
(optional)
Intel
®
RAID Smart Battery AXXRSBBU7
SAS connector Two external SFF8088 connectors
ROC LSI*SAS2108 ROC, which provides hardware exclusive OR (XOR) assistance
Card dimensions 6.600 inches by 2.731 inches (MD2)
Weight 114g
Serial port 4-pin serial debug (requires transceiver)
Compatible devices 240 physical devices, 64 logical drives, mixed capacity drives, SAS and SATA hard drives,
and non-disk devices including expanders.
Firmware 8 MB in flash ROM
2.5 Electrical Characteristics
The PCI Express* Specification requires that the 12-V rail and the 3.3-V rail have a voltage
tolerance of 8% and 9% respectively. The amount of power that an adapter card can use is also
limited.
All power is supplied to the Intel
®
RAID Controller RS2PI008 through the PCI Express* 3.3-V
rails and the 12-V rails. The on-board switching regulator circuitry, operating from these rails,
provides the necessary voltages. The following states determine the typical current consumption
of the controller:
State 1: Battery is charging
State 2: Battery is full
State 3: Battery is discharging
The supply voltages are 12 V ± 8 percent from PCI edge connector only and 3.3 V ± 9 percent
from PCI edge connector only. The following table lists the power supply for the RAID controller
for each state at the different voltages:
Table 6. Electrical Characteristics
PCI Express* +12 V PCI Express* +3.3 V PCI Express* +3.3 V Auxiliary Supply
State 1 950 mA 773 mA 30 mA
State 2 730 mA 773 mA 30 mA
State 3 733 mA 770 mA 30 mA
Revision 1.1
Intel order number E64396-002
12