Technical Product Specification

IntelP®P RAID Controller RS2PI008 Technical Product Specification Hardware
2.3.11 Jumpers and Connectors
The following figure shows the jumpers and connectors on Intel
®
RAID Controller RS2PI008. A
description for each jumper and connector is provided in the following table.
Figure 7 Jumpers and Connectors
Table 4 Jumpers and Connectors
Jumper Description Type Comments
J1A1 Universal Asynchronous
Receiver/Transmitter (UART)
4-pin connector For factory and debug use.
J1A2 Test header 2-pin connector Reserved for factory use only
J1A3 Set Factory Defaults Connector 2-pin connector Resets the board settings to the defaults set in
the factory.
J1A4 External Mini SAS 4i
Connector, Ports 4-7
SFF8088 Connection to SAS/SATA devices.
J1B1 External Mini SAS 4i
Connector, Ports 0-3
SFF8088 Connection to SAS/SATA devices.
J6A1 Drive Fault LED Header 2-pin connector LED signal for any drive fault.
J6A2 Drive Activity LED Header 2-pin connector LED signal for drive activity
J6A3 Dirty Cache LED Header 2-pin connector For connection to enclosure LED. When lit,
indicates the data in the cache has not been
written to disk.
J6B1 Remote Battery Backup Unit
Connector
20-pin connector Provides an interface to the remote battery
backup unit
J6B2 Board-to-board Connector for
Battery Backup Unit
20-pin connector Provides an interface to the daughter card that
contains the battery backup unit.
Revision 1.1
Intel order number E64396-002
11