Enclosure Management Cabling Guide

September 2009
5
SRCS28X (SATA only)
Not supported.
SATA RAID controllers are not
supported with SAS expander
backplanes.
RAID card connector: J13, white
Backplane connector: SES, white
Cable: 3-pin SES
Note: HSC FW 2.05 or higher is required.
RS2BL080
SAS in-band. No drive LED control
cable needed.
RAID card connector: J11, white
Backplane connector: SES, white
Cable: 3-pin SES
RS2BL040
SAS in-band. No drive LED control
cable needed.
RAID card connector: J11, white
Backplane connector: SES, white
Cable: 3-pin SES
RS2PI008 Not supported. Not supported.