Installation Guide

8 Intel
®
RAID Smart Battery AXXRSBBU7 User’s Guide
a 2-56 screw goes into each end. Place three screws from the battery side, and three
from the RAID controller side.
Caution: Center the screwdriver carefully to avoid stripping the screw head. Do not over-tighten
the screws. The maximum recommended torque is 2.25-inches per pound.
Setting up a Remote Connection to the RAID Controller
To install the Intel
®
RAID Smart Battery AXXRSBBU7 on the RAID Controller through
the J2 Remote BBU connector, do the following:.
1. Ground yourself, and remove the Intel
®
RAID Smart Battery AXXRSBBU7 from the
package.
2. Install the plastic standoff to the REB.
Figure 5. Installing the Plastic Standoff on the REB
3. Install the Remote Extension Board (REB) onto the RAID controller’s battery
connector (JT3 on the RS2BL080).
AF003238
A