Hardware user guide

Intel® Integrated RAID Module RMS25KB0x0 and RMS25JB0x0 Hardware User’s Guide 9
Figure 5. Installing the Intel
®
Integrated RAID Module RMS25JB0x0
5. Connect the proper cables into the
adapter using the 4-port combined end. Make
sure the module and cables are properly attached and plug the cable into connector
at the inside edge of the adapter.
Note: T
o prevent throughput problems:
— Use the cables provided or use the
shortest possible cable.
— Do not use cables longer than one meter.
— Decrease the maximum length by one foot if
you are using a backplane.
— Do not use cross-over cables.
— Only connect to a SATA drive, SAS or SATA backplane, or an
expander device.
— Route the cables carefully.
— Check that the module and cables are all properly attached.
AF004669