Service Guide

Hardware Installations and Upgrades
Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide 79
Installing and Removing the Intel
®
Remote
Management Module 4
Installing the Intel
®
RMM4 Lite
Locate the RMM4 Lite connector next to RISER SLOT_1, carefully pickup the Intel
®
RMM4
Lite module, match the alignment pin of the module and the connector on server board, then
press to install.
Figure 106. Installing the Intel
®
RMM4 Lite
Install the Intel
®
RMM4 NIC
1. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will align (see letter
A).
2. Connect the cable to the module (see letter B).
3. Secure the module to the chassis with the two screws (see letter C).
4. Connect the cable to the server board connector (see letter D).
Figure 107. Installing the Intel
®
RMM4 NIC