Service Guide

Hardware Installations and Upgrades
54 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
Installing 8x3.5” Hot-swap Backplane
1. Remove all hot-swap drive carriers, regardless of whether or not a drive is installed in the carrier.
2. Attach the backplane to the back side of the hot-swap drive cage, and make sure the hooks on the
cage are inserted in the backplane holes (see letter A).
3. Push the backplane (see letter B) and secure the backplane with the screw (see letter C).
Figure 68. Installing 8x3.5” Hot-swap Backplane
4. Install the 8x3.5” Hot-swap Hard drives cage. For instructions, see “installing 8x3.5” Hot-swap Hard
Drive Cage Assembly”.
5. Install the front bezel. For instructions, see “Installing the Front Bezel (Pedestal Only)”.
6. Install the air duct if the air duct is removed. For instructions, see the Quick Start User’s Guide or
Service Guide provided with your Intel
®
server/workstation board.
7. Install the chassis cover. For instructions, see “Installing the Chassis Cover”.
8. Plug all peripheral devices and the AC power cable into the server.
9. Power up the server.