Service Guide

Hardware Installations and Upgrades
42 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
7. If not replacing with another drive, reinsert an EMI shield into chassis (see the illustration below).
Figure 53. Re-inserting Empty EMI Shield
Removing and Installing the Fixed HDD EMI Shield
/
NOTE
For a rack configuration or chassis on its side, position the chassis hanging over the edge of a table or
workbench before removing the bezel.
This procedure applies only to the Intel
®
Workstation System P4000CR family with fixed HDD
configuration.
Removing the Fixed HDD EMI Shield
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel. For instructions, see “Removing the front bezel”.