Service Guide

BIOS Setup Utilities
150 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
IOM2 Port1 PXE
Enabled /
Disabled
IOM2 Port2 PXE
Enabled /
Disabled
IOM2 Port3 PXE
Enabled /
Disabled
IOM2 Port4 PXE
Enabled /
Disabled
IOM2 Port1 MAC Address <MAC Address display >
IOM2 Port2 MAC Address <MAC Address display >
IOM2 Port3 MAC Address <MAC Address display >
IOM2 Port4 MAC Address <MAC Address display >
Figure 148. NIC Configuration Screen
Screen Field Descriptions:
1. Wake on LAN (PME)
Option Values: Enabled
Disabled
Help Text:
Enables or disables PCI PME function for Wake on LAN capability from LAN adapters.
Comments: Enables/disables PCI/PCIe PME# signal to generate Power Management Events
(PME) and ACPI Table entries required for Wake on LAN (WOL). However, note that this will
enable WOL only with an ACPI-capable Operating System which has the WOL function enabled.
2. PXE 1GbE Option ROM
Option Values: Enabled
Disabled
Help Text:
Enable/Disable Onboard/IOM NIC PXE Option ROM Load.
Comments: This selection is to enable/disable the 1GbE PXE Option ROM that is used by all
Onboard and IO Module 1 GbE controllers.
This option is grayed out and not accessible if the discs Option ROM is enabled. It can co-exist
with the 10 GbE PXE Option ROM, the 10 GbE FCoE Option ROM, or with an InfiniBand*
controller Option ROM.
If the 1GbE PXE Option ROM is disabled, and no other Option ROM is enabled, the system
cannot perform a Network Boot and cannot respond for Wake-on-LAN.