Service Guide

Hardware Installations and Upgrades
98 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
6. Locate the expander card bracket in the chassis. Mount the expander card to the bracket with screws.
Figure 138. Installing the Expander Card
7. Connect the data cable between server board and expander card, and between expander and
backplane(s). See documents for your server boards for instructions.
8. Install the Fixed HDDs or Hot swap drive cages. For instructions, see “Install Fixed Hard Drives”, or
“Install 8x3.5 Hot swap Drive Cage Assemble”, or “Install 8x2.5 Hot swap Drive Cage Assemble”
9. Install the fans. For instructions, see “Install the Fixed Fan” or “Install the Hot-swap Fans”.
10. Install the chassis cover. For instructions, see “Install the Chassis Cover”.
Removing the Expander card
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, “Removing the Chassis Cover”.
4. Remove the fans. For instructions, see “Removing the Fixed Fan” or “Removing the Hot-swap Fans”.
5. Remove the Fixed HDDs or Hot swap drive cages. For instructions, see “Remove Fixed Hard Drives”,
or “Remove 8x3.5 Hot swap Drive Cage Assemble”, or “Remove 8x2.5 Hot swap Drive Cage
Assemble”.
6. Unplug all the cables connected to the expander card.