Service Guide

Hardware Installations and Upgrades
88 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
Removing and Installing the Chassis Feet
Removing the Chassis Feet
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Lay the chassis down on its right side.
4. Loosen the screws securing the rubber foot to the chassis and then remove the rubber foot from chassis.
Figure 122. Removing the Chassis Feet
5. Repeat above steps until all four feet are removed.
Installing the Chassis Feet (Pedestal Configuration Only)
/
NOTE
Do not install feet on your Intel
®
Server System P4000IP and Intel
®
Workstation System
P4000CR family if it is to be installed in a rack. Only install feet on a pedestal-configured chassis.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Lay the chassis down on its right side.
4. Insert rubber foot into chassis hole (see letter A).