Service Guide

Server System Features
Intel
®
Server System R2000GZ/GL Service Guide 11
For instructions on installing hard drives, see “Installing a Hot-swap Hard Disk Drive”.
Note: Drives can consume up to 17 watts of power each. Drives must be specified to run at a maximum
ambient temperature of 45
°C.
Note: The Intel
®
Server System R2000GZ/GL does not support all SAS or Serial ATA (SATA) hard drives.
For a web link to a list of supported hard drives, see “Additional Information and Software”.
Slimline Optical Drive Support
The system has support for a single optical drive. The optical drive is NOT hot-swappable. The
system power must be turned off to insert or remove the slimline optical drive. For instructions on
installing an optical drive, see “Installing or Removing a Slimline Optical Drive”.
Intel makes the following optical drive accessory kits available for this server system:
• Slimline DVD-ROM Drive: AXXSATADVDROM
• Slimline DVD-RW Drive: AXXSATADVDRWROM
Note: For a complete list of supported peripherals, go to http://serverconfigurator.intel.com
Bezel
The front bezel is available as optional accessory for the server system:
Figure 14. Front view of Front Bezel
Hot-Swap SAS/SATA Backplane
The Hot-Swap SAS/SATA backplane serves as an interface between the mother board and the
system drives. The following diagrams show the location for each connector found on the
backplane.