Service Guide

Hardware Installations and Upgrades
Intel
®
Server System R2000GZ/GL Service Guide 45
Figure 72. Installing the Intel
®
RAID Smart Battery
Removing the Intel
®
RAID Smart Battery
1. Slide the plastic battery holder toward the rear of the system (see letter “A”).
2. Disengage the battery from the server chassis side wall and move it out of the opening in the
fan bulkhead (see letter “B”).
3. Lift the battery up to remove it from the server chassis (see letter “C”).
Figure 73. Removing the Intel
®
RAID Smart Battery
Replacing the Power Supply
Caution: The power supply is only hot-swappable if you have a redundant system with two power
supplies installed. If you only have one power supply installed, before removing or replacing the
power supply, you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the power cord from the
system or wall outlet.
The power supply can be replaced if it fails. To replace the power supply, follow these steps: