Technical Product Specification

Intel® Server Boards S4600LH2/T2 TPS
Revision 2.0
162
Option Values: Enabled
Disabled
Help Text:
Enable/Disable Onboard/IOM NIC Port PXE Boot
Comments: This will enable or disable PXE Boot capability for Port<x, x = 1-4> of Onboard
NIC<n, n = 1-2> or IO Module<n, n = 1-2>.
This option will not appear for ports on a NIC which is disabled, or for individual ports when the
corresponding NIC Port is disabled.
Only ports which actually exist for a particular NIC or IOM will appear in this section. That is, Port1-
Port4 will appear for a quad-port NIC, Port1-Port2 will appear for a dual-port NIC, and only Port1 will
appear for a single-port NIC.
The default state of each Port PXE Boot option is Enabled, if the corresponding PXE Boot OPROM of
the same speed is Enabled. If a PXE Boot OPROM for 1 GbE or 10 GbE changes from Disabled to
Enabled, then the Port PXE Boot option becomes Enabled for all ports of that speed
If the PXE Boot OPROM for1 GbE NICs or 10 GbE NICs is disabled, PXE Boot will be disabled and
grayed out as unchangeable for all ports on NICs or IO Modules of that same speed.
Conversely, if PXE Boot is disabled for all ports of a given speed, the corresponding PXE Option ROM
will be disabled, but not grayed out since it could be selected.
Back to [NIC Configuration Screen] — [PCI Configuration Screen] — [Advanced Screen
]
31. NIC1 Port1 MAC Address
32. NIC1 Port2 MAC Address
33. NIC1 Port3 MAC Address
NIC1 Port4 MAC Address
34. NIC2 Port1 MAC Address
35. NIC2 Port2 MAC Address
36. NIC2 Port3 MAC Address
NIC2 Port4 MAC Address
37. IOM1 Port1 MAC Address
38. IOM1 Port2 MAC Address
39. IOM1 Port3 MAC Address
IOM1 Port4 MAC Address
40. IOM2 Port1 MAC Address
41. IOM2 Port2 MAC Address
42. IOM2 Port3 MAC Address
IOM2 Port4 MAC Address
Option Values: <Mac Address Display>
Help Text: <None>
Comments: Information only. 12 hex digits of the MAC address of Port1- Port4 of the Network
Controller corresponding to NIC1, NIC2, IOM1, or IOM2.
This display will appear only for ports which actually exist on the corresponding Network Controller. If
the Network Controller or port is disabled, the port MAC Address will not appear.
Back to [NIC Configuration Screen] — [PCI Configuration Screen] — [Advanced Screen
]
12.2.2.8 Serial Port Configuration
The Serial Port Configuration screen allows the user to configure the Serial A and Serial B ports. In Legacy ISA
nomenclature, these are ports COM1 and COM2 respectively.