S2600GZ and S2600GL

Table Of Contents
Intel® Server Board S2600GZ/GL TPS Product Architecture Overview
Figure 10. Processor Socket Assembly
There are two variations of the ILM: square and narrow.
Figure 11. Processor Socket ILM Variations
The square ILM has an 80x80mm heat sink mounting hole pattern and is used on the Intel
®
Server
Board S2600GL.
The narrow ILM has a 56x94mm heat sink mounting hole pattern and is used on the Intel
®
Server
Board S2600GZ.
Note: Processor heat sink solutions for the Intel
®
server boards S2600GL and S2600GZ are NOT the same.
Care must be taken when selecting heat sinks for the given server board ensuring the screw layout pattern of
the heat sink matches the screw hole pattern of the ILM.
3.1.2
Processor Population Rules
Note: Although the server board does support dual-processor configurations consisting of different processors
that meet the defined criteria below, Intel does not perform validation testing of this configuration.
For optimal
system performance in dual-processor configurations, Intel recommends that identical processors be installed.
When using a single processor configuration, the processor must be installed into the processor socket labeled
CPU_1”.
Heat Sink
Server Board
Independent Latching
Mechanism (ILM)
Back Plate
80
mm
80
mm
94mm
56mm
Revision 2.4
13