Service Guide

Hardware Installations and Upgrades
44 Intel
®
Server System R2000GZ/GL Service Guide
Removing a Solid State Drive
1. Disconnect cables (see letter “A”).
2. Remove the four screws to release the Solid State Drive (see letter “B”).
3. Pull the Solid State Drive up to remove from the air duct (see letter “C”).
Figure 71. Removing a SSD
Installing and Removing the Intel
®
RAID Smart Battery
Installing the Intel
®
RAID Smart Battery
1. Connect the cable between the BBU and the RAID card. For details, see Intel
®
RAID Smart
Battery User’s Guide.
2. Locate the mounting holes inside the chassis and reposition all cables routed over the fan
bulkhead. Position the battery against the side wall and through the opening in the fan bulkhead
(see letter “A”).
3. Align the tabs on the plastic battery holder with the mounting holes in the chassis and slide the
plastic battery holder toward the front of the system until the tabs engage with the mounting
holes (see letter “B”).