Specifications

Monthly Specification Update

24.

System fan speed may not slow down as expected after hot-swapping a

failed fan within the Intel® Server System R2000GZ/GL Product Family

Problem System does not recognize a hot-swapped fan causing the fans to run at high

speed.

Implication After a system fan failure, the remaining fans will speed up to maintain proper

system cooling. After replacing the failed fan with a new one, the system will

continue to operate fans at high speed until a system reboot is performed.

Status This issue was fixed in FRUSDR 1.07 and later release.

Workaround None.

25.

Intel

FDR InfiniBand* ConnectX* -3 I/O Module may not comply with FCC

and Industry Canada regulations

Problem Intel

FDR InfiniBand* ConnectX* -3 I/O Module AXX1FDRIBIOM and

AXX2FDRIBIOM may not comply with Part 15 of the Federal Communications

Commission (FCC) and Industry Canada regulations when used with copper

InfiniBand* cables.

Implication Except for not complying with FCC and Industry Canada regulations when used

with copper InfiniBand* cables, no other functionality impact. And except for the

United States of America and Canada where the regulations apply, no other

countries are impacted.

Status This issue was fixed by Mellanox* InfiniBand* ConnectX* -3 firmware 2.11.1308

and later release. Please refer to the following website for downloading:

http://www.mellanox.com/page/firmware_table_Intel

Workaround None.

26.

The Intel® Xeon Phi™ Coprocessor PCI Express* Card Status Sensor may

show "Unknown"

Problem When only one Intel® Xeon Phi™ Coprocessor PCI Express* Card (MIC card)

is installed in the server system, the card status sensor “MIC 1 Status” or “MIC

2 Status” may show “Unknown” in Intel® Integrated BMC Web Console.

Implication Users may not get the correct MIC status in Intel® Integrated BMC Web

Console. There is no function impact to the server system. This issue doesn’t

happen when two Intel® Xeon Phi™ Coprocessor PCI Express* Cards are

installed.

Status This issue was fixed in BMC 01.19.5018 and later release.