Specifications

Hardware Installations and Upgrades
Intel
®
Server System R2000BB Service Guide 45
Installing and Removing the Intel
®
Remote Management
Module 4
Installing the Intel
®
RMM4 Lite
Locate the RMM4 Lite connector next to Riser Slot 1, carefully pickup the Intel
®
RMM4 Lite
module, match the alignment pin of the module and the connector on server board, then press to
install.
Figure 67. Installing the Intel
®
RMM4 Lite
Install the Intel
®
RMM4 NIC
1. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will align
(see letter “A”).
2. Position the module over the server board, fit the front of the module into the back panel slot,
then attach the module to the server board connector (see letter “B”).
3. Secure the module with the two screws as shown (see letter “C”).
4.
Figure 68. Installing the Intel
®
RMM4 NIC