Specification Update

Monthly Specification Update
9
16. Hard drives connected through SAS expander can’t be detected in
legacy mode
Problem If hard drives are connected through expander to SCU ports and configured
under RSTe mode, the hard drives can’t be detected by system in legacy mode
(default BIOS setting).
Implication Users cannot use the hard drives connected through expander as boot device
to install OS. But users can install OS to other hard drives which are not
connected through expander and load RSTe driver to make the hard drives
connected through expander visible to OS. Or users can change Boot Options
> EFI Optimized Boot to Enabled in BIOS Setup so that hard drives
connected through expander can be detected by the system.
Status This issue was fixed in BIOS 01.08.0003 and later release.
Workaround None
17. On-board VGA cannot be set to the highest resolution (1920x1080 and
higher)
Problem The Graphics ID register in the on-board video controller is getting set
incorrectly.
Implication The video cannot be set to the highest resolutions listed here:
[1920x1080,High 256 Color, 60 Hertz]
[1920x1200,High 256 Color, 60 Hertz]
[1920x1080,High Color(16bit), 60 Hertz]
[1920x1200,High Color(16bit), 60 Hertz]
Status This issue was fixed in BMC release 1.16.4010.
Workaround None
18. Integrated BMC Web Console – Sensor Readings Page – Memory
Throttling sensor status will stay “Critical” once triggered
Problem When Memory Throttling is triggered, the Memory P1 MTT and/or P2 MTT
sensor status will stay at Critical status in the Integrated BMC Web Console
even after throttling has stopped.
Implication You may observe Memory P1 MTT and/or P2 MTT status as Critical even
when there is no throttling. No functional impact to the system.
Status This issue was fixed in ME 02.01.07.328 and later release.
Workaround Need a AC cycle or reset ME through IPMI to reset the MTT sensor status.