Service Guide

Hardware Installations and Upgrades
Intel
®
Server System R1000SP Service Guide 19
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the four screws (see letter A).
5. Slide cover back and lift upward (see letter B).
Figure 25. Removing the System Cover
Installing the System Cover
1. Place the top cover on system and slide towards the front of chassis until the recessed front
edge is fully engaged (see letter A).
2. Install the three screws at the front and torque to 7-9in-lbs, then install the screw at the
back and torque to 7-9in-lbs (see letter B).
Figure 26. Installing the System Cover