Service Guide

Server System Features
Intel
®
Server System R1000SP Service Guide 9
Peripheral Devices
The Intel
®
Server System R1000SP provides locations and hardware for installing hard drives, CD-ROM
drive, or DVD-ROM drive. The following figure shows the available options:
A
System Label Pull-out
B
Slimline Optical Drive Bay
C
Video Port
D
USB Ports
E
Front Control Panel
F
Hard Disk Drive Bays
Figure 11. Optional Peripherals (8x2.5-inch hard drive bays as shown)
Hard Disk Drive Carriers
The Intel
®
Server System R1000SP ships with either 3.5-inch or 2.5 inch hard disk drive carrier, and with
different maximum number of hard disk drives.
Note: SAS drives are only supported when proper Intel
®
RAID C600 Upgrade Key or Intel
®
Integrated
RAID Module is installed.
For instructions on installing hard drives, see “Installing a Hot-swap Hard Disk Drive”.
Note:
1. Drives can consume up to 17 watts of power each. Drives must be specified to run at a
maximum ambient temperature of 45°C.
2. The Intel
®
Server System R1000SP does not support all SAS or Serial ATA (SATA) hard drives.
For a web link to a list of supported hard drives, see “Additional Information and Software”.
Slimline Optical Drive Support
The system has support for a single optical drive. The optical drive is NOT hot-swappable. The system
power must be turned off to insert or remove the slimline optical drive. For instructions on installing an
optical drive, see “Installing or Removing a Slimline Optical Drive”.
Intel
®
makes the following optical drive accessory kits available for this server system:
• Slimline DVD-ROM Drive: AXXSATADVDROM
• Slimline DVD-RW Drive: AXXSATADVDRWROM