R2000GZ and R2000GL

Intel
®
Server System R2000GZ/GL Product Family TPS
Thermally, the system can support the following PCI add-in cards.
• Add-in cards with a minimum 100 LFM (0.5 m/s) air flow requirement can be installed in any available
add-in card slot in both Riser Card #1 and Riser Card #2
• Add-in cards with a minimum 200 LFM (1 m/s) air flow requirement can be installed in any available
add-in card slot on Riser Card #2 and the bottom add-in card slot on Riser Card #1. Middle and Top
add-in card slots on Riser Card #1 cannot support PCI add-in cards with air flow requirements greater
than 100 LFM.
• Add-in cards with a >200 LFM air flow requirement cannot be supported.
Note: Most PCI add-in cards have minimum air flow requirements of 100 LFM (0.5m/s). Some high power add-
in cards have minimum air flow requirements of 200 LFM (1 m/s). System integrators should verify PCI add-in
card air flow requirements from vendor specifications when integrating add-in cards into the system
10.3 Riser Card Options
Several multi-slot PCI riser card options are available for this server product family. All available riser card
options can be installed in either riser card slot on the server board.
10.3.1 3-Slot PCIe Riser Card
Slot #
Description
PCIe Lane Routing
Riser Slot # 1
PCIe Lane Routing
Riser Slot #2
Slot-1 (Top)
PCIe x8 lanes, x16 slot
CPU1
CPU2
Slot-2 (Middle)
PCIe x8 lanes, x16 slot
CPU1
CPU2
Slot-3 (Bottom)
PCIe x8 lanes, x8 slot
CPU2
CPU2
68 Revision 2.2