System Service Guide

Hardware Installations and Upgrades
20 Intel
®
Server System R1000JP Family Service Guide
unplug all peripheral devices and the power cable(s).
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the screws (see letter A).
5. Slide cover back and lift upward (see letter B).
Figure 23. Removing the System Top Cover
Installing the System Cover
1. Place the top cover on the system and slide it towards the front of chassis until the recessed
front edge is fully engaged. (see letter A).
2. Install the three screws at the front and torque to 7-9in-lbs, then install the screw at the
back and torque to 7-9in-lbs. (see letter B).