Technical Product Specification
Intel® Server Board S1600JP TPS Product Architecture Overview
DDR-II/III memory interface supports up to 256MB of memory
Supports all display resolutions up to 1600 x 1200 16bpp @ 60Hz
High speed Integrated 24-bit RAMDAC
The integrated video controller supports all standard IBM VGA modes. The following table
shows the 2D modes supported for both CRT and LCD:
Table 11. Video Modes
2D Mode
Refresh Rate (Hz)
2D Video Mode Support
8 bpp 16 bpp 32 bpp
640x480
60, 72, 75, 85, 90,
100, 120, 160, 200
Supported
Supported
Supported
800x600
60, 70, 72, 75, 85,
90, 100, 120,160
Supported
Supported
Supported
1024x768
60, 70, 72,
75,85,90,100
Supported
Supported
Supported
1152x864
43,47,60,70,75,80,85
Supported
Supported
Supported
1280x1024
60,70,74,75
Supported
Supported
Supported
1600x1200**
60
Supported
Supported
Supported
** Video resolutions at 1600x1200 are only supported through the external video
connector located on the rear I/O section of the server board. Utilizing the
optional front panel video connector may result in lower video resolutions.
The server board provides two video interfaces. The primary video interface is accessed using a
standard 15-pin VGA connector found on the back edge of the server board.
In addition, video
signals are routed to a 14-pin header labeled “FP_Video” on the leading edge of the server
board, allowing for the option of cabling to a front panel video connector.
Attaching a monitor to
the front panel video connector will disable the primary external video connector on the back
edge of the board.
The BIOS supports dual-video mode when an add-in video card is installed. In the single mode
(dual monitor video = disabled), the on-board video controller is disabled when an add-in video
card is detected.
In the dual mode (on-board video = enabled, dual monitor video = enabled), the on-board video
controller is enabled and is the primary video device. The add-in video card is allocated
resources and is considered the secondary video device. The BIOS Setup utility provides
options to configure the feature as follows:
Table 12. Video mode
On-board Video
Enabled
Disabled
Dual Monitor Video
Enabled
Disabled
Shaded if on-board video is set to "Disabled"
Revision 1.9 33