Technical Product Specification

Configuration Jumpers Intel® Server Board S1600JP TPS
5. Remove AC power.
6. Move the jumper back to default position, covering pins 1 and 2.
7. Close the server chassis.
8. Power up the server.
The BIOS settings are now cleared and you can reset it by going into the BIOS setup.
Note: Removing AC Power before performing the BIOS settings Clear operation causes the
system to automatically power up and immediately power down, after the procedure is followed
and AC power is re-applied. If this happens, remove the AC power cord again, wait 30 seconds,
and re-install the AC power cord. Power-up the system and proceed to the <F2> BIOS Setup
Utility to reset the desired settings.
154 Revision 1.9