Technical Product Specification

Configuration Jumpers Intel® Server Board S1600JP TPS
Table 54. Password Clear Jumper
Jumper
Position
Mode of
Operation
Note
1-2
Normal
Normal mode, password in protection.
2-3
Clear Password
BIOS password is cleared.
Steps to clear the BIOS password:
1. Power down server. Do not unplug the power cord.
2. Open the chassis. For instructions, see your Server Chassis Documentation.
3. Move jumper (J1B6) from the default operating position, covering pins 1 and 2, to the
password clear position, covering pins 2 and 3.
4. Close the server chassis.
5. Power up the server, wait 10 seconds or until POST completes.
6. Power down the server.
7. Open the chassis and move the jumper back to default position, covering pins 1 and 2.
8. Close the server chassis.
9. Power up the server.
The password is now cleared and you can reset it by going into the BIOS setup.
6.4
BIOS Recovery Mode (J2B3)
The Intel
®
Server Board S1600JP uses BIOS recovery to repair the system BIOS from flash
corruption in the main BIOS and Boot Block. This 3-pin jumper is used to reload the BIOS when
the image is suspected to be corrupted. For directions on how to recover the BIOS, refer to the
specific BIOS release notes.
Table 58. BIOS Recovery Mode Jumper
Jumper
Position
Mode of Operation
Note
1-2
Normal
Normal mode.
2-3
Recovery
BIOS in recovery mode.
You can accomplish a BIOS recovery from the SATA CD and USB Mass Storage device.
Please note that this platform does not support recovery from a USB floppy.
The recovery media must contain the following files under the root directory:
1. RML.ROM
2. UEFI iFlash32 11.0 Build 2 (including iFlash32.efi and ipmi.efi)
3. *Rec.CAP
4. Startup.nsh (update accordingly to use proper *Rec.CAP file)
The BIOS starts the recovery process by first loading and booting to the recovery image file
(RML.ROM) on the root directory of the recovery media (USB disk). This process takes place
152 Revision 1.9