S2600GZ and S2600GL

Intel® Server Board S2600GZ/GL TPS BIOS Setup Utility
Comments: Selection only. Position to this line and press the <Enter> key to discard any
pending unsaved changes in BIOS settings. If there have been no changes made in the settings, the
BIOS will resume executing POST.
If changes have been made in BIOS settings and not yet saved, a confirmation pop-up will appear. If
the “Discard Changes” action is positively confirmed, all pending changes will be discarded and BIOS
will resume executing POST. If the “Discard Changes” action is not confirmed, BIOS will resume
executing Setup without discarding pending changes.
Back to [Save & Exit Screen
]
5. Load Default Values
Option Values: <None>
Help Text:
Load Defaults Values for all the setup options.
Comments: Selection only. Position to this line and press the <Enter> key to load default
values for all BIOS settings. These are the initial factory settings (“failsafe” settings) for all BIOS
parameters.
There will be a confirmation popup to verify that the user really meant to take this action.
After initializing all BIOS settings to default values, the BIOS will resume executing Setup, so the user
may made additional changes in the BIOS settings if necessary (for example, Boot Order) before doing
a “Save Changes and Exit” with a reboot to make the default settings take effect, including any changes
made after loading the defaults.
The <F9> function key may also be used from anyplace in Setup to initiate a “Load Default Values”
action.
Back to [Save & Exit Screen
]
6. Save as User Default Values
Option Values: <None>
Help Text:
Save the changes made so far as User Default Values.
Comments: Selection only. Position to this line and press the <Enter> key to save the current
state of the settings for all BIOS parameters as a customized set of “User Default Values”.
These are a user-determined set of BIOS default settings that can be used as an alternative instead of
the initial factory settings (“failsafe” settings) for all BIOS parameters.
By changing the BIOS settings to values that the user prefers to have for defaults, and then using this
operation to save them as “User Default Values”, that version of BIOS settings can be restored at any
time by using the following “Load User Default Values” operation.
There will be a confirmation popup to verify that the user really intended to take this action.
Loading the “factory default” values with F9 or the “Load Default Values” – or by any other means –
does not affect the User Default Values. They remain set to whatever values they were saved as.
Back to [Save & Exit Screen
]
7. Load User Default Values
Option Values: <None>
Help Text:
Load the User Default Values to all the setup options.
Revision 2.4
193