Intel Server Board S2400BB

Intel® Server Board S2400BB TPS
Revision 2.0
83
6. Boot to the EFI shell and update the ME firmware using the “MEComplete####.cap” file (where #### =
ME revision number) using the following command: iflash32 /u /ni MEComplete####.cap
7. When update has successfully completed, power off system
8. Remove AC power cords
9. Move ME FRC UPD jumper back to the default position
Note: If the ME FRC UPD jumper is moved with AC power applied, the ME will not operate
properly. The system will need have the AC power cords removed, wait for at least 10 seconds and
then reinstalled to ensure proper operation.
10. Install Riser Card
11. Install AC power cords
12. Power on system
9.3 Password Clear Jumper Block
This jumper causes both the User password and the Administrator password to be cleared if they were set.
The operator should be aware that this creates a security gap until passwords have been installed again
through the BIOS Setup utility. This is the only method by which the Administrator and User passwords can be
cleared unconditionally. Other than this jumper, passwords can only be set or cleared by changing them
explicitly in BIOS Setup or by similar means. No method of resetting BIOS configuration settings to default
values will affect either the Administrator or User passwords.
1. Power down the server and unplug the power cords.
2. Open the chassis and remove the Riser #1 assembly
3. Move jumper from the default (pins 1 and 2) operating position to the password clear position (pins 2
and 3).
4. Close the server chassis and reattach the power cords
5. Power up the server and wait until POST completes.
Note: BIOS Error Manager should report a 5224 and 5221 error codes (Password clear jumper is set
and Passwords cleared by jumper)
6. Power down the server and unplug the power cords.
7. Open the chassis, remove the Riser #1 assembly, and move the jumper back to the default position
(covering pins 1 and 2).
8. Reinstall the Riser #1 assembly
9. Close the server chassis and reattach the power cords.
10. Power up the server
9.4 BIOS Default Jumper Block
This jumper resets BIOS Setup options to their default factory settings.
1. Power down the server and unplug the power cords
2. Open the chassis and remove the Riser #1 assembly
3. Move BIOS DFLT jumper from the default (pins 1 and 2) position to the Set BIOS Defaults position
(pins 2 and 3)
4. Wait 5 seconds then move the jumper back to the default position of pins 1 and 2
5. Install riser card assembly
6. Install Power Cords
7. Power on system
Note: Following the above procedure, the BIOS will report various error messages in the Error
Manager. This is normal and should not occur on subsequent system boot ups after setting and saving
desired BIOS Setup options.