Intel Server Board S2400BB

Intel® Server Board S2400BB TPS
Revision 2.0
76
8.2.4 Intel
®
Local Control Panel Connector
The server board includes a 7-pin connector that is used when the system is configured with the Intel
®
Local
Control Panel with LCD support. On the server board this connector is labeled “LCP” and is located on the
front edge of the board. The following table provides the pin-out for this connector.
Table 32. Intel Local Control Panel Connector Pin-out ("LCP")
Signal Description
Pin#
SMB_SENSOR_3V3STBY_DATA_R0
1
GROUND
2
SMB_SENSOR_3V3STBY_CLK
3
P3V3_AUX
4
FM_LCP_ENTER_N_R
5
FM_LCP_LEFT_N_R
6
FM_LCP_RIGHT_N_R
7
8.3 On-Board Storage Connectors
The server board provides connectors for support of several storage device options. This section provides a
functional overview and pin-out of each connector.
8.3.1 Single Port SATA Only Connectors
The server board includes one white single port SATA only connectors capable of transfer rates of up to 6Gb/s.
On the server board this connector is labeled as “SATA 1”. The following table provides the pin-out for this
connector.
Table 33. Single Port AHCI SATA Controller Connector Pin-out "SATA 1")
Signal Description
Pin#
GROUND
1
SATA_TXP
2
SATA_TXN
3
GROUND
4
SATA_RXN
5
SATA_RXP
6
GROUND
7
8.3.2 Multiport Mini-SAS/SATA Connectors
The server board includes two 40-pin high density multiport mini-SAS/SATA connectors. On the server board,
these connectors are labeled as “SCU_0 (0-3)” supporting the chipset embedded SCU 0 controller, and
“SCU_1 (4-7)”, supporting the embedded SCU 1 controller. Both connectors can support up to four SATA or
SAS ports each. By default, only the connector labeled “SCU_0 (0-3)” is enabled and has support for up to four
SATA ports capable of transfer rates of up to 6Gb/s. The connector labeled “SCU_1 (4-7)” is only enabled
when an optional 8-port SAS or SATA Intel
®
RAID C600 Upgrade Key is installed. See Table 9. Intel
®
RAID
C600 Upgrade Key Options for a complete list of supported storage upgrade keys. The following tables
provide the pin-out for each connector.