Intel Server Board S2400BB

Intel® Server Board S2400BB TPS
Revision 2.0
27
USB. The server board utilizes nine USB 2.0 ports from the chipset. All ports are high-speed, full- speed, and
low-speed capable.
• Three external USB ports are provided in a stacked housing located on the rear I/O section of the
server board
• Two USB ports are routed to an internal 10-pin connector (Labeled “FP_USB” on the server board) that
can be cabled for front panel support
• One internal Type ‘A’ USB port
• One eUSB connector intended for use with an optional eUSB SSD device
• Two USB ports are routed to the integrated BMC
3.3.2.1 eUSB SSD Support
A 2mm 2x5-pin connector labeled “LP_eUSB_SSD” near Riser Slot #2 on the server board is used to provide
support for a low profile eUSB SSD storage device.
Figure 18. Low Profile eUSB SSD Support
eUSB SSD features include:
• 2 wire small form factor Universal Serial Bus 2.0 (Hi-Speed USB) interface to host
• Read Speed up to 35 MB/s and write Speed up to 24 MB/s
• Capacity range from 256 MB to 32 GB
• Support USB Mass Storage Class requirements for Boot capability
• Visit http://www.intel.com\support
for a list of supported devices.
3.3.3 Network Interface
On-board network connectivity is provided by means of an Intel
®
Ethernet Controller I350-AM4 providing up to
four 10/100/1000 Mb Ethernet ports. The NIC chip is supported by x4 PCIe Gen2 signals from the IIO module
of the CPU 1 processor.
Bottom View
Top View