Data Sheet

ManualsBrandsIntel ManualsDevelopment Kit Add-onsPL-USB2 BLASTER Development Board 1/pk

Figure 3-1: Hardware Setup Dialog Box

The Hardware Settings tab of the Hardware Setup dialog box is displayed.

4. From the Currently selected hardware drop-down list, select USB-Blaster [USB-0].

5. Click Close to close the Hardware Setup dialog box.

6. In the Programmer window, select the desired programming mode from the Mode drop-down list.

Table 3-1: Programming Modes

Mode Description

Joint Test Action Group (JTAG) Programs or configures all supported Altera devices except EPCS,

EPCQ, and EPCQ-L devices.

In-Socket Programming USB-Blaster does not support this programming mode.

Passive Serial Configures all supported Altera devices except EPCS, EPCQ, and

EPCQ-L devices.

Active Serial Programming Programs a single EPCS, EPCQ, or EPCQ-L device.

Connecting the USB-Blaster Download Cable to the Board

1. Disconnect the power cable from the device board.

2. Connect the USB-Blaster download cable to your PC.

3. Plug the USB-Blaster download cable into the 10-pin header on the device board.

UG-USB81204

2015.08.20

Connecting the USB-Blaster Download Cable to the Board

3-3

Using the USB-Blaster Download Cable

Altera Corporation

Send Feedback

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.