Specification Update

October, 2014 Monthly Specification Update

15. After installing Windows 2008* R2 SP1 on the Intel

Server Board

S1200V3RP, the VM cannot be started when a RemoteFX* 3D virtual

graphic card is installed in the VM of Hyper-V

Problem After installing Windows 2008* R2 SP1 on the Intel

Server Board S1200V3RP,

the VM cannot be started when a RemoteFX* 3D virtual graphic card is

installed in the VM of Hyper-V. If VHD (RmoteFX) is disabled, the Hyper-V VM

can start normally.

Implication The VHD feature doesn’t work on Windows 2008* R2 SP1.

Status Will not fix.

Workaround Enter the BIOS setup page and set the primary display interface as Processor

Integrated Graphics.

16. The Intel

ROC Modules RMS25CB080 and RMS25CB040 may not be

detected on the Intel

Server Board S1200V3RPL, S1200V3RPM, and

S1200V3RPO if any devices are connected on the IO Module connector

or PCIe Slot5

Problem The Intel

ROC Modules RMS25CB080 and RMS25CB040 may not be

detected on the Intel

Server Board S1200V3RPL, S1200V3RPM, and

S1200V3RPO if any devices are installed on the IO Module connector or PCIe

Slot5. If no device is installed on the IO Module connector and PCIe Slot5, this

issue will not occur.

Implication The Intel

ROC Modules RMS25CB080 and RMS25CB040 may not be

detected. It is a hardware design limitation.

Status Will not fix.

Workaround No.

17. The Intel

Server Board S1200V3RPS and S1200V3RPL may not

recognize certain PCIe storage devices in slot4 during POST

Problem Intel has found a corner case compatibility scenario with some add-in storage

adapters in PCIe slot4 where the adapters may sometimes not be present on

boot. The PCIe slot4 is designed using PCI-Express specification compliant

polarity inversion and meets Intel’s design and quality criteria.

Implication The Intel

Server Board S1200V3RPS and S1200V3RPL may not recognize

certain PCIe storage devices in slot4 during POST.

Status The issue may be fixed in a future BIOS release.