Service Guide

Server Utilities
92 Intel
®
Server System R1000RP Service Guide
IOM2 Port4 MAC Address
<MAC Address display >
Figure 87. NIC Configuration Screen
Screen Field Descriptions:
1. Wake on LAN (PME)
Option Values: Enabled
Disabled
Help Text: Enables or disables PCI PME function for Wake on LAN capability from
LAN adapters.
Comments: Enables/disables PCI/PCIe PME# signal to generate Power Management
Events (PME) and ACPI Table entries required for Wake on LAN (WOL). However, note that
this will enable WOL only with an ACPI-capable Operating System which has the WOL
function enabled.
Back to [NIC Configuration Screen] — [NIC Configuration Screen] — [Advanced Screen] —
[Screen Map]
2. PXE 1GbE Option ROM
Option Values: Enabled
Disabled
Help Text: Enable/Disable Onboard/IOM NIC PXE Option ROM Load.
Comments: This selection is to enable/disable the 1GbE PXE Option ROM that is
used by all Onboard and IO Module 1 GbE controllers.
This option is grayed out and not accessible if the iSCSI Option ROM is enabled. It can co-
exist with the 10 GbE PXE Option ROM, the 10 GbE FCoE Option ROM, or with an
InfiniBand controller Option ROM.
If the 1GbE PXE Option ROM is disabled, and no other Option ROM is enabled, the system
cannot perform a Network Boot and cannot respond for Wake-on-LAN.
This 1GbE PXE option does not appear unless there is a 1 GbE NIC installed in the system as
an Onboard or IO Module NIC.
Back to [NIC Configuration Screen] — [NIC Configuration Screen] — [Advanced Screen] —
[Screen Map]
3. PXE 10GbE Option ROM
Option Values: Enabled
Disabled
Help Text: Enable/Disable Onboard/IOM NIC PXE Option ROM Load.
Comments: This selection is to enable/disable the 10GbE PXE Option ROM that is
used by all Onboard and IO Module 10 GbE controllers.