Technical Product Specification

Power Subsystem Intel
®
Server System R1000RP Family TPS
Intel order number: G91532-003 Revision 1.3
18
3.1.4.13 Surge Immunity
The power supply shall be tested with the system for immunity to AC Ring Wave and AC
Unidirectional Wave, both up to 2kV. The power supply shall operate normally without any
component damage under any condition.
BI-WAVE 12Ω±2.0kV (Common mode)
2Ω±1.0kV (Differential mode)
RING-WAVE 500A±2.0kV (Common mode)
500A±1.0kV (Differential mode)
3.1.4.14 Power Recovery
The power supply should recover automatically after an AC power failure. AC power failure is
defined as any loss of AC power that exceeds the dropout criteria.
3.1.4.15 Voltage Interruptions
The power supply shall comply with the limits defined in EN55024: 1998/A1: 2001/A2: 2003
using the IEC 61000-4-11: Second Edition: 2004-03 test standard and performance criteria C
defined in Annex B of CISPR 24.
3.1.5 DC Output Specification
3.1.5.1 Output Power/Currents
The following table defines the output power and current ratings.
Table 11. Output Current Requirements
Notes:
1. The total current of +12V1/2 will not exceed 28A.
2. The total output for this PSU is 350W.
3. The total output of +3.3V & +5V will not exceed 100W.
3.1.5.2 Standby Output
The 5VSB output should be present when an AC input greater than the power supply turn on
voltage is applied.
3.1.6 Protection Circuits
The protection circuits inside the power supply should cause only the power supply’s main
outputs to shut down. If the power supply latches off due to a protection circuit tripping, an AC
Output
Minimum
Maximum
Output Power
+3.3V
0.1A
10A
33W
+5V
0.1A
16A
80W
+12V1
0.75A
18A
216W
+12V2
0.75A
18A
216W
-12V
0.0A
0.5A
6W
+5VSB
0.05A
2.5A
12.5W