Service Guide

Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide 57
Figure 34. Installing an Add-In Card
9. Install the PCIe* Riser assembly into the server system. For instructions, see
“Installing the PCIe* Riser Assembly” on page 53.
10. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29.
11. Plug all peripheral devices and the AC power cable into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28.
4. Remove the PCIe* Riser assembly. For instructions, see “Removing the PCIe*
Riser Assembly” on page 52.
5. Remove the screw at the rear of the riser assembly. You will use it later.
6. Pull the add-in card from the socket in the riser assembly. You may need to wriggle
the card from front to back to remove it, but use caution so you do not twist or bend
the card.
7. Install a filler panel over the opening at the rear of the riser assembly.
AF003694
Riser Connector
REMOVE Filler Panel
A
B
Add-in Card
C