User manual

Intel® Quark™ Microcontroller Developer Kit D2000
April 2016 User Guide
Document Number: 333966-002EN 9
2.2 Board Photo
Figure 2. Intel® Quark™ Microcontroller Developer Kit D2000 Fab D Board Photo
2.3 Board Jumpers
1. FTDI UART/JTAG*
J12 and J13 Jumpers are installed for both JTAG and UART by default.
To isolate the Intel® Quark ™ microcontroller D2000 from the FTDI FT232HL,
remove all the sleeves from Jumpers J7, J9, J10, J12, and J13.
• J7 [2-3] JTAG (Default) [1-2] UART
• J9 [2-3] JTAG (Default) [1-2] UART
• J10 [2-3] JTAG (Default) [1-2] UART
2. Power
• Place J19 Jumper at [1-2] (Default) when the USB Port is in use.
• Place J25 Jumper at [1-2] (Default) when the USB Port is in use.
• J23 Jumper [1-2] (Default)
*Note: Debug and firmware loading is currently only supported via JTAG. By using
UART_B, your application disables the JTAG interface.