Network Card User Manual

88 MPCMM0001 Chassis Management Module Software Technical Product Specification
The Command Line Interface (CLI)
cmm1EthernetA
cmm1EthernetB
cmm2EthernetA
cmm2EthernetB
Used only with the CMM
location to change the eth0/
eth1 direction to either the
front panel, the rear panel IO
card, or backplane on CMM1
and/or CMM2.
Both
"Front" or "Rear" or "Backplane". For
example,
bash-2.04# cmmget -d
cmm1ethernetA
cmm1ethernetA: front
bash-2.04# cmmget -d
cmm1ethernetB
cmm1ethernetB: front
bash-2.04# cmmget -d
cmm2ethernetA
cmm2ethernetA: front
bash-2.04# cmmget -d
cmm2ethernetB
cmm2ethernetB: front
"Front", "Rear", or
"Backplane"
version
The version of the CMM
software.
Get
"Version:
[Generation].[SRA].[Patch].[Build]"
where Generation: Firmware
Generation. SRA: Release in that
Generation. Patch: Patch number.
Build: Build number. E.g.
Version:5.1.0.11
N/A
update
Used with the cmmget
command to update the CMM
firmware on the CMM.
In a redundant system,
updates should only be done
on one CMM at a time in order
to maintain chassis
management.
Refer to Section 23, “Updating
CMM Software” on page 204
for additional information.
Set N/A
"<cmm image
location>
ftp:<hostname or IP
address>:username
:password"
redundancy
Returns the list of CMMs in the
shelf and their status.
Get
CMM 1: Present (active) *
CMM 2: Not Present (standby)
* = The CMM you are currently logged
into.
N/A
failover
Used with cmmset from the
active CMM to force a failover
to the standby. This will only
complete successfully if the
standby CMM is in a state
where it can handle a failover.
Set N/A
“1” = Failover to
standby CMM with
equal or newer
firmware version.
“any”= Failover to
standby CMM
regardless of
firmware version.
rmcpenable
Enable/Disable RMCP
interface.
Both
"1" - RMCP Enabled
"0" - RMCP disabled
"1" - RMCP Enable
"0" - RMCP disable
Table 27. Dataitem Keywords for Cmm Location (Sheet 3 of 7)
dataitem Description
Get/
Set
CLI Get Output Valid Set Values