Network Card User Manual

MPCMM0001 Chassis Management Module Software Technical Product Specification 147
SNMP
24 cmmAlarmTimeOut INTEGER read-write
The timeout value in minutes for the
Telco Alarm cutoff. This is the amount
of time before the alarm cutoff will
automatically become unset if the user
doesn't unset it themselves. A value of
0 will disable the timeout. This dataitem
is only valid when used with the cmm as
the location and is used to set the alarm
timeout or get its value.
25 cmmCriticalLED INTEGER read-write
The LED on the CMM faceplate that
indicates presence of critical events in
the system. 1 - Set, 0 - Clear
26 cmmMajorLED INTEGER read-write
The LED on the CMM faceplate that
indicates presence of major events in
the system. 1 - Set, 0 - Clear
27 cmmMinorLED INTEGER read-write
The LED on the CMM faceplate that
indicates presence of minor events in
the system.1 - Set, 0 - Clear
28 cmmFailover INTEGER write
Used to induce a failover from the
active cmm to the standby cmm.
1 - Enable, 2 - any
29 -
34
cmmsEthernetA
cmmsEthernetB
cmm1EthernetA
cmm1EthernetB
cmm2EthernetA
cmm2EthernetB
INTEGER read-write
When get, it displays the Eth0 or Eth1
connectors of both CMMs, CMM1, or
CMM2.
When set, it routes the selected
Connection between the front or rear
connectors. Valid Values: front / rear
35 cmmListLocations DisplayString read-only list of Locations information
36 cmmListPresent DisplayString read-only list of Present Entities information
37 cmmPowerBudget DisplayString read-only
38 cmmBusedEkeys DisplayString read-only
39 cmmClearSel INTEGER write
To clear the SEL set the object with 1 to
clear. Other value - has no effect
40 cmmPowerSequence DisplayString read-write
List of boards/delay pairs indicating the
power sequence of the boards in the
Chassis
41 cmmPowerState DisplayString read-write
This is used to find out the current
power state of the CMM. Format text -
Location: CurrentState (Mx) where Mx
is the ATCA-defined M state of the
location.
Settable value:reset, poweron, poweroff
42 cmmFeedCount DisplayString read-only Get the power feed count
43 cmmFRUExtractionNotify INTEGER write
This is an Intel extension command for
PICMG 3.0. Used to notify the Shelf
Manager that a FRU has been
extracted from the shelf. Valid value: 1
Table 63. Cmm Location (1.3.6.1.4.1.343.2.14.2.10.3) (Sheet 2 of 3)
OID Object Syntax Access Value