Datasheet

Errata
Specification Update 67
AH63. Removed Erratum
AH64. Returning to Real Mode from SMM with EFLAGS.VM Set May Result in
Unpredictable System Behavior
Problem: Returning back from SMM mode into real mode while EFLAGS.VM is set in SMRAM may
result in unpredictable system behavior.
Implication: If SMM software changes the values of the EFLAGS.VM in SMRAM, it may result in
unpredictable system behavior. Intel has not observed this behavior in commercially
available software.
Workaround: SMM software should not change the value of EFLAGS.VM in SMRAM.
Status: For the steppings affected, see the Summary Tables of Changes.
AH65. VMLAUNCH/VMRESUME May Not Fail when VMCS Is Programmed to
Cause VM Exit to Return to a Different Mode
Problem: VMLAUNCH/VMRESUME instructions may not fail if the value of the “host address-
space size” VM-exit control differs from the setting of IA32_EFER.LMA.
Implication: Programming the VMCS to allow the monitor to be in different modes prior to
VMLAUNCH/VMRESUME and after VM-exit may result in undefined behavior
Workaround: Software should ensure that "host address-space size" VM-exit control has the same
value as IA32_EFER.LMA at the time of VMLAUNCH/VMRESUME.
Status: For the steppings affected, see the Summary Tables of Changes.
AH66. IRET under Certain Conditions May Cause an Unexpected Alignment
Check Exception
Problem: In IA-32e mode, it is possible to get an Alignment Check Exception (#AC) on the IRET
instruction even though alignment checks were disabled at the start of the IRET. This
can only occur if the IRET instruction is returning from CPL3 code to CPL3 code. IRETs
from CPL0/1/2 are not affected. This erratum can occur if the EFLAGS value on the
stack has the AC flag set, and the interrupt handler's stack is misaligned. In IA-32e
mode, RSP is aligned to a 16-byte boundary before pushing the stack frame.
Implication: In IA-32e mode, under the conditions given above, an IRET can get a #AC even if
alignment checks are disabled at the start of the IRET. This erratum can only be
observed with a software generated stack frame.
Workaround: Software should not generate misaligned stack frames for use with IRET.
Status: For the steppings affected, see the Summary Tables of Changes.