User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index

4-50 PRO/100 LAN+Modem PC Card User’s Guide
The I/O test failed - Please select a different I/O address
The driver failed the I/O test. Try a different I/O address.
The IRQ test failed - Please select a different IRQ
The driver failed the IRQ test. Try a different IRQ address.
Please specify either IO or MEM for the MODE keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the MODE keyword in the NET.CFG or
PROTOCOL.INI file must be either IO or MEM.
Please specify a decimal number for the COMIRQ keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the COMIRQ keyword in the NET.CFG or
PROTOCOL.INI file must be a decimal number.
Please specify a hexadecimal number ending in 8 for the
COMBASE keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the COMBASE keyword in the NET.CFG or
PROTOCOL.INI file must be a hexadecimal number in the range 248 to
3F8.
No standard COM ports available. Please use custom COM port
(COMIRQ, COMBASE)
This message applies to both the ODI and NDIS 2.0 drivers. All COM
ports (COM1 - COM4) are being used. Create a custom COM port by
adding the COMIRQ and COMBASE keywords, with assigned values, to
the NET.CFG or PROTOCOL.INI file.
The selected COM IRQ is in use by another device
The IRQ value set for the COM port is already in use by another device.
Assign a different IRQ value for the COM port.