User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index

4-48 PRO/100 LAN+Modem PC Card User’s Guide
The card is unreadable, possible memory conflict
The Card Information Structure (CIS) of the PC Card was unreadable.
This could be a result of failure to exclude the selected memory range
from the memory managers loaded on the machine. Either exclude a 8K
memory range, select a memory range that has already been excluded, or
include the NOCHECK keyword in the configuration file.
Please specify a different interrupt for the modem
The LAN adapter and modem cannot be configured for the same
interrupt. Either select a different modem interrupt (using the COMIRQ
keyword or a different COM port value), or select a different LAN
interrupt (using the INTERRUPT keyword).
The COMBASE keyword is required in this configuration
If the COMIRQ keyword has been specified, but COM1, COM2, COM3,
or COM4 has NOT been specified, the COMBASE keyword must be
specified with an appropriate value.
The COMIRQ keyword is required in this configuration
If the COMBASE keyword has been specified, but COM1, COM2,
COM3, or COM4 has NOT been specified, the COMIRQ keyword must
be specified with an appropriate value.
The Network Controller is not responding
A PRO/100 PC Card was detected, but subsequent attempts to initialize
the network controller failed. Try setting the WORDSIZE parameter to 8.
Please specify a decimal number for the INTERRUPT keyword
This message applies only to the NDIS 2.0 Driver. The value specified
under the INTERRUPT keyword in the PROTOCOL.INI file must be a
decimal not a hexadecimal number.