User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index
1-4 PRO/100 LAN+Modem PC Card User’s Guide
Package Contents
EtherExpress PRO/100 LAN+Modem PC Card PC Card (Model
MBLA1656)
Model MBLA-1656: Ethernet adapter cable with a 15-pin PC Card
connector at one end and female RJ-45 connector at the other for
10Base-T or 100Base-TX connectivity
Modem cable with RJ-11 telephone connector
Intel EtherExpress PRO/100 LAN+Modem PC Card User's
Guide
(this book)
Intel EtherExpress PRO/100 LAN+Modem PC Card Quick
Start card
Software on two 1.44 MB 3.5-inch diskettes
Protective adapter case
6-foot telephone cable
Product registration card
Other Required Equipment
1 For LAN operations: a local area network supporting 10 or
100Mbps Ethernet, as required, and a network operating system
supported by the PRO/100 PC Card.
Note
Since the PRO/100 PC Card automatically detects the speed of
the network to which it is connected, it may be safely connected
to either a 100Base-TX or 10Base-T network, as specified in
items 2 and 3 below.
2 For connection to a 100Base-TX Ethernet network, a Category 5
(data grade) unshielded twisted pair (UTP) network cable terminat-
ing in a male RJ-45 connector and connected to a 100Mbps hub or
switch.
3 For connection to a 10Base-T Ethernet network, a network cable
terminating in a male RJ-45 connector and connected to a 10Mbps
hub or switch.