User's Manual
Table Of Contents
- Contents
- Hardware Installation
- Software Supplied
- Hardware Installation
- Unpacking and Inspection
- Other Required Equipment
- Installing Card and Cables
- PRO/100 Modem and Ethernet Connections
- Windows* 95 Installation
- Which Version of Windows 95?
- How Can I Tell Which Version I Have?
- Additional Information in this Chapter
- Windows 95 Installation (Retail Version)
- Windows 95 OSR2 Installation (OEM Version)
- How to Install for Windows 95 and NetWare*
- Utilities
- Power-Saving Modes
- Windows 95 Troubleshooting
- Troubleshooting Checklist
- Windows 95 Driver Parameters Reference
- Windows NT Installation
- Which Version of Windows NT?
- How Can I Tell Which Version and Service Pack I Have?
- Additional Information in this Chapter
- Windows NT 4.0 Installation
- Windows NT 3.51 Installation
- Power-Saving Modes
- Utilities
- Windows NT Driver Parameters Reference
- Windows 3.x/DOS Installation
- Installation under MS-DOS
- Windows 3.x Network Driver Parameters
- ODI Settings (for M16BODI.COM)
- Error Messages for Windows 3.x and MS-DOS Drivers
- Windows 3.x Troubleshooting
- Computer-Specific Application Notes (Windows 3.x)
- Utilities and Applications
- Utilities
- Country Identifier Utility
- Modem Test Utility
- Diagnostic Test Utility (M16BTEST.EXE)
- COM port monitor (Windows 3.x only)
- Communications Application Notes and Modem
- Modem Reference
- Result Codes
- AT Command Reference
- S-Register Reference
- Automated Customer Support
- Specifications
- Agency Notices
- Software License Agreement
- Index
4-40 PRO/100 LAN+Modem PC Card User’s Guide
NDIS 2.0.1 Settings (for driver
M16BNDIS.EXE)
Custom parameters for the NDIS driver can be entered manually, using an
ASCII editor, in the PROTOCOL.INI file.
NDIS 2.0.1 DOS Driver Configuration Notes
The DOS NDIS driver M16BNDIS.EXE conforms to the Microsoft
Network Driver Interface Specification (NDIS) version 2.0.1. It is a DOS-
based executable terminate-and-stay-resident (TSR) program that will
configure itself according to the options specified in the PROTOCOL.INI
file, which is supplied on Disk 2. Network Drivers Disk.
The files required for using M16BNDIS.EXE are:
PROTOCOL.INI Configuration and binding informa
tion file
M16BDOS.NIF Intel installation file for Microsoft
LAN Manager
M16BNDIS.EXE Intel DOS NDIS 2.0.1 driver
Most installations will be able to use the settings detected by the driver. If
any parameters need to be changed, use an ASCII text editor to modify
the PROTOCOL.INI file with the appropriate keywords and values.
Keyword syntax for PROTOCOL.INI can be found below. Keywords are
not case sensitive, and can be abbreviated to a unique sequence of initial
characters (for example, IN for INTERRUPT, IO for IOADDRESS). A
Keyword Alphabetical Reference follows the keyword listings.
PROTOCOL.INI Example
[INTELNET]
DRIVERNAME=INTEL
MEM=0XD2000
MODE=IO